OK. Here is all the stock for making the aileron. Note the small gray rectangle in the center. That is a block of lead used as a counterweight to balance the ailerons. I have to cut that piece in half on the diagonal. Most of the rest of the pieces are preformed in the kit for this section. I just have to fab small clips from the angle, cut the lead, cut and pilot drill the hinge and cut the aileron skins to shape. I started with the hinge halves. Since I will use my hinge drilling jig, I have to mark a two inch area that will not be drilled using the jig. There is a special pattern in that area. The other 35 holes in each hinge piece are drilled in the jig. |