Click on a picture to
view a larger image
With the connector and new boot in place I just connected them all to the ignition coils.  All four ignition sources are now completely wired up!
      The last step before closing out the Firewall Forward area is to run fuel.  The first step is to perform three machining operations on the Aerocarb. Two proscribed by Sonex and one of my own.

      Since the Aerocarb can be installed lots of ways on lots of engines, some things are left for you to perform as needed. The mixture cable I used is slightly larger than the machined hole in the body.  You open this hole up to fit your cable.  The third picture shows the enlarged hole with the nearby setscrew that secures the cable – the setscrew comes into play in my modification. The last picture shows the other end of the hole.