Click on picture to
view a larger image.
Getting to that one was by far the hardest.

For this one, I used my two support stands to each hold one end of a long 2x4 that was supported on the other end by the table. I then slid the whole frame onto those two 2x4’s and the frame was now supported over the space between the car and the table.

I had room to have all the tools accessible on the edge of the table. I could not stand up however and sat on two different height stools depending on what I was attaching.
      The first picture shows the general installation order I followed.  Position the former and clamp it to the clip at the top and the channels at the bottom.  Drill the top, done in this picture, and then drill the bottom, shown still clamped and undrilled.  Then do the other one the same way.  Since I don’t want to have to get back in here, I also then updrill all these holes to the final size.
          Then it is outside to drill the holes to attach the formers to the turtle deck skin and it’s all drilled!