After the fuel system, my plan was to finish the gear and get the airplane on the ground. To do that required some work to be able to rearrange the shop. The weather has been a problem for some of the work I wanted to do because I needed to do it outside of the garage. Which meant I would be getting wet!
So before moving on, a played around with some seat foam. I needed to cut it and some of the cuts would be on an angle. Surprisingly, it cut perfectly on the band saw! These pictures show how I cut a piece short at an angle and then glued it with Scotch 90 spray adhesive. The bend is where the foam will go over the spar tunnel. A nice diversion.
